2S Mini F411 flight control 16*16mm integrated OSD/BEC

Product Category: Toy electronic accessories

Toy category: electric toy

F411 Flight control instructions

Usage Instructions (Required reading)

There are many flight control integration functions and dense components. Do not use tools (such as needle-nose pliers or sleeves) to screw the nuts during installation. This may cause unnecessary damage to the tower hardware. The correct method is to press the nut tightly with your fingers, and the screwdriver can quickly tighten the screw from the bottom. (Remember not to be too tight, so as not to damage the PCB)

Do not install the propeller during the installation and commissioning of the flight control. Before installing the propeller for test flight, please check the motor steering and the direction of the propeller again. Do not use non-original aluminum column or nylon column to avoid damage to the flight control hardware. The official standard is custom sized nylon column to fit the flight tower.

Before the aircraft is powered on, please check again whether the installation between the flying tower inserts is correct (pin or wire alignment must be installed), check again whether the welded positive and negative poles are correct, and check whether the motor screws are against the motor stator to avoid short circuit. Check whether the electronic components of the flying tower have been thrown out of the solder, which may lead to a short circuit. If the short circuit occurs in the installation welding, the buyer shall bear the responsibility.

Specification parameters:

Dimensions: 20*20MM,

Screw fixing hole distance: 16*16MM, hole distance: M2

Package size: 37*34*18mm

Weight: 3g Packing weight: 7.5g

Basic configuration:

Sensor: MPU6000 three-axis accelerometer/three-axis gyroscope (SPI connection)

CPU:  STM32F411C

Power supply: 2S battery input

Integration: LED_STRIP, OSD

BEC: 5V/0.5A

Built-in LC filter, BF firmware support (F411 firmware)

Buzzer/Programming LED/ Voltage monitoring /BLHELI modulation programming;

Receiver configuration:

Support Sbus or serial RX interface,Spektrum 1024/2048, SBUS, IBUS, PPM, etc

1, DSM,IBUS,SUBS receiver input, please configure RX1 as the input interface.

2, PPM receiver does not need to configure UART port.

Suitable for traversing machine frame: the size of the following frame within 70mm is suitable (the 70mm frame can play a small but full function advantage)

Features:

Small size (external size is only 20*20mm), integrated with a adjustable color LED light, simple and convenient wiring