F405DJI Flight controller Dual BEC barometer dual Gyroscope 3-6S Traverser Race

Product Category: Toy electronic accessories

Toy Category: Other toys

F405 DJI flight control

Usage Instructions (Required reading)

1. The flight control has many integrated functions and dense components. Do not use tools (such as needle-nose pliers or sleeves) to screw the nuts during installation, which may scratch the tower hardware and cause unnecessary losses. The correct method is to press the nut tightly with your fingers, and the screwdriver can quickly tighten the screw from the bottom. (Remember not to be too tight, so as not to damage the PCB)

2. Do not install the propeller during the installation and debugging of flight control, and try not to test it indoors to avoid safety accidents. Before installing the propeller for test flight, double check that the motor steering and propeller orientation are correct. Safety tips: Do not fly near crowds, the company will not be responsible for all losses caused by aircraft crash.

3. Do not use non-original aluminum column or nylon column to avoid damage to the flight control hardware. The official standard is custom sized nylon column to fit the flight tower.

4. Before the aircraft is powered on, please check again whether the installation between the flying tower inserts is correct (pin or wire alignment must be installed), check again whether the welded positive and negative poles are correct, and check whether the motor screws are against the motor stator to avoid short circuit. 5. Check whether there is any solder thrown out on the electronic original of the flying tower, which may lead to short circuit. If the short circuit occurs in the installation and welding, the buyer shall bear the responsibility.

Specification and size

Size: 36x36mm

Packing size: 62*33mm

Mounting hole distance: 30.5×30.5mm*4mm

Weight: 6g

Packing weight: 20g

Processor: STM32F405RGT6

Gyroscope: MPU6000

B E C: 5V/3A; 9 v / 2.5 A

Storage: 16MB

Input voltage: 3-6s

Firmware: betaflight_4.1.0_MATEKF405

Uart Serial ports: 5

Assembly list: 4530D flight control motherboard x1, shock absorber ring x4, 8p soft silicone wire x1, DJI high-definition picture transmission cable x1