F722DJI Flight controller Dual BEC barometer dual Gyroscope 3-6S Traverser Race

Product Category: Toy electronic accessories

Toy Category: Other toys

F722 DJI flight control

Usage Instructions (Required reading)

There are many flight control integration functions and dense components. Do not use tools (such as needle-nose pliers or sleeves) to screw the nuts during installation. This may cause unnecessary damage to the tower hardware. The correct method is to press the nut tightly with your fingers, and the screwdriver can quickly tighten the screw from the bottom. (Remember not to be too tight, so as not to damage the PCB)

Do not install the propeller during the installation and debugging of flight control, and try not to test it indoors to avoid safety accidents. Before installing the propeller for test flight, double check that the motor steering and propeller orientation are correct. Safety tips: Do not fly near crowds, the company will not be responsible for all losses caused by aircraft crash.

Do not use non-original aluminum column or nylon column to avoid damage to the flight control hardware. The official standard is custom sized nylon column to fit the flight tower.

Before the aircraft is powered on, please check again whether the installation between the flying tower inserts is correct (pin or wire alignment must be installed), check again whether the welded positive and negative poles are correct, and check whether the motor screws are against the motor stator to avoid short circuit.

Check whether the electronic components of the flying tower have been thrown out of the solder, which may lead to a short circuit. If the short circuit occurs in the installation welding, the buyer shall bear the responsibility.

Specification and size

Size: 36x36mm

Packing size: 62*33mm

Mounting hole distance: 30.5×30.5mmx4mm

Weight: 6g

Packing weight: 20g

Processor: STM32F722RET6

Gyroscope: MPU6000/ICM20602 (choose one of the two, one of them is standby and cannot be used at the same time)

B E C: 5V/3A; 9 v / 2.5 A

Storage: 16MB

Input voltage: 3-6s

Solid parts: betaflight_4.1.0_MATEK722

Uart Serial ports: 5

Assembly list: 7230D flight control motherboard x1, shock absorber ring x4, 8p soft silicone wire x1,DJI HD image transmission cable x1