Racing crossing machine F405 V3 flight control 50A four-in-one electrical modulation into OSD 5V9V dual BEC

Product Category: Toy electronic accessories

Origin: Shenzhen, Guangdong

Toy category: electric toy

F405 flight control, flight tower instructions

Usage Instructions (Required reading)

There are many flight control integration functions and dense components. Do not use tools (such as needle-nose pliers or sleeves) to screw the nuts during installation. This may cause unnecessary damage to the tower hardware. The correct method is to press the nut tightly with your fingers, and the screwdriver can quickly tighten the screw from the bottom. (Remember not to be too tight, so as not to damage the PCB)

Do not install the propeller during the installation and debugging of flight control, and try not to test it indoors to avoid safety accidents. Before installing the propeller for test flight, double check that the motor steering and propeller orientation are correct. Safety tips: Do not fly near crowds, the company will not be responsible for all losses caused by aircraft crash.

Do not use non-original aluminum column or nylon column to avoid damage to the flight control hardware. The official standard is custom sized nylon column to fit the flight tower.

Before the aircraft is powered on, please check again whether the installation between the flying tower inserts is correct (pin or wire alignment must be installed), check again whether the welded positive and negative poles are correct, and check whether the motor screws are against the motor stator to avoid short circuit.

Check whether the electronic components of the flying tower have been thrown out of the solder, which may lead to a short circuit. If the short circuit occurs in the installation welding, the buyer shall bear the responsibility.

F405 flight control size:

Size: 36x36mm

Packing size: 62*58*17mm

Mounting hole distance: 30.5×30.5mmx4mm

Weight: 6g

Packing weight: 20g

Processing device: STM32F405RGT6

Touron: MPU6000

B E C: 5V/2A; 9 v / 1.5 A

Storage: 16MB

Input voltage: 3-9s

Fixed parts: beta flight_3.5.5_F405

Uart Serial ports: 5

Assembly list: F405 flight control motherboard x1, shock absorber ring x4, 8p soft silicone wire x1

50A 4-in-1 electric modulation:

Fixed hole distance: 30.5*30.5mm/Φ3mm

Continuous current: 50A

Maximum current: 65A (sustainable 10S)

Input voltage: 3–6S

Hardware performance:

50A power modulation adopts STSPIN32F0A 32-bit high-performance processor.

The original imported MOS tube is used, and the double MOS is in parallel so that the heat is lower.

PCB board using 3OZ copper thick multilayer board more strong flow

BEC output of 5V/3A supports voltage return and current data transmission

Driver signal support: Dshot150/300/600/1200, Multishot, PWM, One shot.

Packing size: 62*58*35mm

Packing weight: 65g