Raspberry PI POE+ HAT

Hardware connection:
Before installing the PoE+ HAT, install the supplied copper posts at the four corners of the circuit board. After connecting the PoE+HAT to the 40Pin and 4-pin PoE ports of the Raspberry PI, the PoE+HAT can be connected to the PoE device through a network cable for power supply and networking. When removing the PoE+HAT, pull the POE + Hat evenly to release the module smoothly from the pin of the Raspberry PI and avoid bending the pin

Software description:
The PoE+ HAT is equipped with a small fan, which is controlled by the Raspberry PI via I2C. The fan will automatically turn on and off according to the temperature of the main processor on the Raspberry PI. To use this product, ensure that the software of the Raspberry PI is a new version

Note:
● This product can only be connected to the Raspberry Pi via four PoE pins.
Any external power supply devices/power injectors used to enable Ethernet shall comply with applicable regulations and standards in the intended country.
● This product should be operated in a well-ventilated environment, if used in the chassis, the chassis should not be covered.
A GPIO connection connecting an incompatible device to a Raspberry Pi computer may affect compliance and cause damage to the device and void the warranty.
All peripherals used with this product shall comply with the relevant standards of the country of use and be marked accordingly to ensure that safety and performance requirements are met.
These articles include, but are not limited to, a keyboard, monitor, and mouse when used in conjunction with a Raspberry Pi computer.
If the connected peripherals do not include a cable or connector, the cable or connector must provide adequate insulation and operation to meet relevant performance and safety requirements.
Safety information
In order to avoid failure or damage to this product, please note the following:
● Do not touch water or moisture during operation, or place on conductive surfaces.
● Do not be exposed to heat from any source. The Raspberry Pi computer and Raspberry Pi PoE+ HAT are designed to operate reliably at normal ambient room temperature.
● Be careful when handling to avoid mechanical or electrical damage to the printed circuit board and connectors.
● Avoid taking the printed circuit board when it is powered on, and only grasp the edges to minimize the risk of electrostatic discharge damage.